.: EPETEKNIK SDN BHD :.
 REMOTE ALARM MONITORING SYSTEM (RAMS)
 
 
SCADATRON REMOTE ALARM MONITORING SYSTEM APPLICATION

SCADATRON Remote Alarm Monitoring (RAMS) is a cost effective Monitoring System developed in Malaysia and has already been put to work successfully in many application areas. The following are some of the possible application
areas:

  • Reservoir/Pipeline Monitoring
  • Flood Monitoring and Warning System
  • Remote Hydrological Data Collection
  • Distributed Irrigation Management System
  • Public Messaging / Warning System
  • Light-House Monitoring System
  • Remote Facilities Alarm Monitoring
  • Building Automation System
  • Dam Monitoring System

Virtually any signals can be measured or counted can be sent over Remote Monitoring / Telemetry Systems. Here are some typical signals: Water tank levels, Liquid flow totals through a pipe, High or low level alarms, Computed gas flow totals, Pipeline pressures & temperatures, Voltages and currents on a transmission system, Switch and alarm positions.
 
         SCADATRON Remote Alarm Monitoring Unit (RAMU) Advantages
 

  • SCADATRON RAMU (ST2000) is a compact / embedded single board controller card which ease the work of
    maintenance services.

  • ST2000 has direct connection to radio transceiver of all brand (Motorola, Philips, Kyodo, Tait) for long distance data communication (distance > 50KM) or to GSM Modem for GSM Data Linkage or SMS Data Reporting.

  • ST2000 can provide direct connection to low orbiting satellite equipment (ORBCOMM) or INMARSAT-C. It can be installed anywhere in the world!

  • ST2000 has direct connection to most type of hydrological sensors, e.g. SEBA, Greenspan, Nohken, etc. Parallel shaft encoder : ADC16, SEBA IWC20, etc. Serial shaft encoder: SEBA MDS-surfloat, OTT OWK16
    Pressure sensors : OTT, SEBA, Greenspan, Nohken Ultra-sonic level sensor : MOBREY, E&H, Danfoss

  • ST2000 has its pulse capturing algorithm to measure fast pulse rate from flow totaliser or slow pulse rate from rainfall gauge.

  • ST2000 has 8 channel of 4 4--20mA analogue input with smart algorithm to give a stable and accurate instrumentation/ sensor reading

  • ST2000 comes with a standard set of keypad and LCD interface for user friendly interface

  • ST2000 has integrated data logging facilities which can store up to 3 months data based on 15 minutes interval (based on 4 measured parameters with full time stamp)

  • ST2000 has flexible radio communication configuration include store-and-forward (SAF), RAMU can relay data
    from another RAMU back to Central Station!

  • The ST2000 has very low power consumption specially designed for solar powered operations.

  • The ST2000 is designed for harsh environment which minimise the use of connectors and plug in circuit board and with built-in power-line surge protection.

  • Application software embedded in the ST2000 runs under a powerful and fast real --time multitasking ope r- rating system ating system. Modification on RTU’s operation can be done in days by our local programmer

  • It is Year 2000 compliance

  • ST2000 RAMU is local make, high quality and low in
    price!
 
         What Is The System's Monitoring Capability?
 

The range is as wide as the whole spectrum of water, irrigation, sewerage, power, building management installation monitoring needs:

  Pumps : running, stopped, overload, failure
  Power : failure, low voltage, tripped
  Sewerage Well : high/low alarm, actual level
  Reservoirs : high/low alarm, high-high/low-low alarm, actual level
  Treatment Plant : water quality, filtration, chemical dosing
  Motors : running, stopped, overload, failure, hours run
  Valves : open, closed, set point
  Pipeline : flow rate, no flow, totalized flow
  Water Quality : Turbidity, Residual Chlorine, pH
  River/Dam : water level, flow rate, discharge
  Irrigation : gate position, water level
  Meteorology : rainfall, wind speed, evaporation
 
 
         Remote Alarm Monitoring Unit (RAMU) Configuration
 

User Interface through Keypad & LCD
RTU with a wall mounting IP65 chassis
REMOTE ALARM MONITORING UNIT (RAMU) CONFIGURATION The components for typical Remote Alarm Monitoring (RAM) Outstations include:
  • ST2000 Remote Alarm Monitoring Unit (RAMU) Controller Card with CPU enclosure
  • IP65 wall mounting enclosure or 13U 19” equipment rack mount chasis
  • Communication equipment (radio transceiver, Satellite Communicator, PSTN MODEM,
    GSM MODEM, etc.) & Antenna System
  • Solar power supply (12V DC) or AC power supply (240V AC)

The ST2000 Remote Alarm Monitoring Unit (RAMU) is a micro-controller based intelligent and versatile measurement and control unit. The system is robust in design and compactly constructed to suit applications in harsh industrial environments.

Unavailability of Telecom landlines in no way precludes application of Scadatron equipment,
because it can also be used over HF, VHF, UHF radio channels, GSM cellular network or satellite
communications. When solar power has to be employed, Scadatron RAMU - with their low
power consumption - are an ideal choice.
 

           

 
 
Home |  Site Map  |  E-mail
Copyright © 2003 Epeteknik Sdn Bhd